Go to SendWork
Full access

Whether sales tax belongs on a construction invoice depends on whether the job makes you a consumer of the materials or a retailer of them — and New York, Texas and Washington answer that three different ways. Here is the test, the trap in how you write the contract, and what to check before you price work in a new state.
Ask a contractor about sales tax on construction work and the first question back is usually “what’s the rate here?” That is the wrong question, and it is why so many invoices are wrong in one direction or the other.
The rate is the last thing you need. The first is whether this job makes you a consumer of the materials or a retailer of them. That single distinction decides whether tax belongs on the customer’s invoice at all. The answer is not the same in every state, and not the same for every kind of work. In at least one state it is not even the same for two contracts covering identical work.
Most states treat a contractor who improves real property as the end consumer of what goes into it. You buy the timber, the wire and the fittings, you pay sales tax at the counter, and that tax is a cost you build into your price. You do not add a separate sales tax line for the customer, because the tax has already been paid — by you.
The alternative treatment makes you a retailer. You buy the materials free of tax using a resale or reseller certificate, and then you collect sales tax from the customer on what you charge. Same work, same materials, completely different paperwork and a visibly different invoice.
Which one applies is a question of state law, and the states genuinely disagree.

These are not edge cases. They are three large construction markets, each published by its own revenue department, and they land in three different places.
| State | Who pays tax on materials | Does the customer see a sales tax line? |
|---|---|---|
| New York | The contractor, at purchase | Not on a capital improvement. Yes on repair, maintenance and installation work |
| Texas | Depends on the contract form | Never on residential labor. On nonresidential repair and remodeling, the whole charge is taxable |
| Washington | Nobody, at purchase — materials are bought for resale | Yes. The prime contractor collects retail sales tax on the gross contract price |
Washington is the clearest illustration that there is no national rule to fall back on. A prime contractor there gives a reseller permit to the supplier and buys the materials without tax. At the other end, they collect retail sales tax from the landowner on the gross contract price, stated separately on the invoice. A contractor doing the same work in New York pays the tax at the merchant’s counter and never shows the customer a tax line at all.
Texas is worth understanding even if you never work there, because it shows how much can turn on how you write the quote rather than what you actually do.
Under a lump-sum contract — one price for the whole job — you pay tax on your supplies, materials and equipment when you buy them, and you do not charge your customer tax. Under a separated contract, you itemize materials and labor. You give suppliers a resale certificate instead of paying tax on the materials, then collect sales tax from the customer on the materials portion.
Two quotes for the same extension, one written as a single figure and one written as a breakdown, put the tax in two different places. Neither is wrong. But if you quote one way and invoice the other, the numbers stop reconciling, and you are the one who has to explain it.
Texas also splits on the property rather than the contract. Labor to repair, remodel or restore residential property is not taxable. The same work on nonresidential property — an office, a warehouse, a shop — is taxable on the total charge. A contractor who works across both is running two rules out of the same truck.
Where a state distinguishes between improving property and fixing it, that line does most of the work. New York publishes the clearest version of the test. A job is a capital improvement only if it meets all three parts:
Building a deck, fitting kitchen cabinets, installing a water heater: capital improvements, no tax to the customer. Repairing a broken step, replacing a thermostat, repainting existing cabinets: taxable services. The gap between “installing” and “replacing” is a sales tax decision, and it is one you make when you write the job up, not when you file.
New York also gives you the document that protects you. The property owner hands the contractor a Certificate of Capital Improvement, Form ST-124, and holding it relieves the contractor of liability for tax on that work. If you take the customer’s word for it and skip the form, the liability is yours, and it surfaces at audit rather than at handover. Get the certificate at the same time you get the signed quote, while the customer still wants something from you.
If you cross a state border to do jobs, you are potentially registered in both. Physical presence in a state — your crew, on a site, doing work — is the oldest form of nexus there is. It generally creates an obligation to register and file there, however little you sell. Economic nexus thresholds were written for remote sellers and do not rescue a contractor whose people are physically on the ground.
The practical version: before you price work in a state you have not worked in, find out which of the three treatments above it uses, and whether it wants you registered. That is a call to that state’s department of revenue, or an hour with an accountant who practices there. It is not something to infer from how your home state works.
Is this job an improvement or a repair, in the language your state uses? Not in the language you and the customer use. The words in the contract should match the words in the statute, and where a certificate exists to prove the answer, it should be in the file before the work starts.
Does your quote and your invoice put the tax in the same place? If the quote was a single figure and the invoice itemizes, or the other way round, the tax treatment may have moved without anyone deciding it should. That is the error that shows up years later, and by then the customer has gone.
Neither question needs an accountant. Both need the answer written down somewhere better than memory, because the next audit asks about a job you have forgotten and an invoice you did not keep. Your state’s department of revenue publishes the rules for free, and it is the only source that binds you — a national guide, including this one, tells you what to go and check.
ON THE JOB THE AUDITOR PICKS
The quote and the invoice have to still agree three years later.
Whether a job was quoted as one figure or itemized, what the customer signed, and what the invoice finally said are the facts this turns on — and they are exactly the ones that live in a folder, a phone and somebody’s memory. SendWork keeps the quote, the job and the invoice attached to each other, so finding the one the auditor asked about takes a search instead of an afternoon.